Wacker Neuson Light Towers LTN 6L 60Hz Operating Manual 0171883en

[Martin Welker]

Download this document, you need 500 Gallons

Wacker Neuson Light Towers LTN 6L 60Hz Operating Manual 0171883en
Size: 13.06 MB
Format: PDF
Language: English
Brand: Wacker Neuson
Type of Machine: Light Towers
Type of Manual: Operating Manual
Model: Wacker Neuson LTN 6L 60Hz Light Towers
Part Number: 0171883en
Publication Date: 2010
Number of Pages: 102 Pages

Contents:
Foreword
1 Safety Information
1.1 Signal Words Used in this Manual
1.2 Machine Description and Intended Use
1.3 Safety Guidelines for Operating the Machine
1.4 Operator Safety while Using Internal Combustion Engines
1.5 Lamp Safety
1.6 Service Safety
2 Labels
2.1 Label Locations
2.2 Label Meanings
3 Operation
3.1 Locating Trailer
3.2 Leveling Trailer
3.3 Adjusting Lights
3.4 Preparing Trailer for Towing or Lifting
3.5 Raising Tower (Manual Winch System)
3.6 Lowering Tower (Manual Winch System)
3.7 Raising Tower (Power Winch System)
3.8 Lowering Tower (Power Winch System)
3.9 Emergency Crank Handle (Power Winch System)
3.10 Control Panels (Manual Winch System)
3.11 Control Panels (120/240, Manual Winch System)
3.12 Control Panels (Power Winch System)
3.13 Starting
3.14 Manual Shutdown
3.15 Automatic Shutdown
3.16 Operating Lights
3.17 Stopping
3.18 Derating
3.19 Receptacle
4 Schematics
4.1 Electrical Schematic
4.3 Trailer Wiring
4.4 Engine Wiring - Lombardini
4.5 Control Panel Wiring
4.6 Power Winch Schematic
5 Maintenance
5.1 Installing / Removing Light Fixtures
5.2 Replacing / Removing Lamps
5.3 Daily Inspection
5.4 Air Cleaner
5.5 Engine Oil
5.6 Periodic Maintenance Schedule
5.7 Troubleshooting
6 Technical Data
6.1 Engine
6.2 Generator
6.3 Machine
7 Appendix I-Assembly Instructions
7.1 Introduction
8 Appendix II-Assembly Safety
8.1 Signal Words Found in this Manual
8.2 Lifting Safety
8.3 Pre-Assembly Checklist
9 Appendix III-Standard Pallet Assembly
9.1 Installing the Outriggers and Outrigger Jacks
9.2 Installing the Rear Jack
9.3 Installing the Tongue Assembly
9.4 Conclusion
10 Appendix IV-CE Pallet Assembly
10.1 Installing the Side Jacks
10.2 Installing the Rear Jack
10.3 Conclusion
11 Appendix V-Standard Racked Assembly
11.1 Installing the Axle
11.2 Installing the Fenders
11.3 Installing the Wheels
11.4 Installing the Outriggers and Outrigger Jacks
11.5 Installing the Rear Jack
11.6 Installing the Tongue Assembly
11.7 Installing the Tower Lock Bracket
11.8 Installing the Tower Cradle
11.9 Installing the Tower
11.10 Installing the Tower Pivot Cable
11.11 Installing the Lights
11.12 Connecting the Wiring at the Junction Box
11.13 Routing the Coil Cord
11.14 Wiring the Ballasts and Terminal Strips
11.15 Conclusion